In our case, Andrew will torque the M12 bolts holding these steel jaws to 80 foot pounds

Use a smaller torque value for aluminum jaws to avoid distorting the screw seats

We set the remaining values conservatively based on the insert we're using to cut these steel jaws

Steel jaws will be used where clamping forces are higher and jaw longevity is important

Second, it's important to choose the right sized jaw

This set of short steel jaws was bored to one inch deep while being held at 100 psi

When attaching the uncut jaws to the chuck always torque the jaws in place

And refer to the chuck documentation for the correct torque value

Pain in jaw spasm of the jaw muscles (trismus)

Of a kind used for persons, in motor vehicles

Milling machines, knee type

For working flat products

Other screws and bolts, whether or not with their nuts or washers

Forged or stamped, but not further worked

All steel!

Yeah, steeljacketed.

Bottlecrate bottlerack

Intermediate bulk container, woven plastic, coated and liner

Box, steel

Case, steel

Drum, steel

Envelope, steel

Jerrican, steel

Consisting of two panels of glass sealed around the edges by an airtight joint and separated by a layer of air, other gases or a vacuum

Bulldozer or angledozer blades

Of coloured glass

Combine harvester threshers

This is seldom, if ever, done any more.

Directoraat generaal Wonen, Wijken en Integratie (Directorate General for Housing, Communities and Integration)

Air heaters and hot air distributors, not electrically heated, incorporating a motor driven fan or blower, of iron or steel, excluding parts thereof

Single stage

Zinc alloys

Unit construction machines (single station)

Raspings, turnings and granules, graded according to size powders

Shaping or slotting machines

Tableware and kitchenware

Cherries

Food supplements, n.e.s.

Lockjaw?

Steel shutters.

Bobbin BB

Cylinder CY

Intermediate bulk container, woven plastic, with liner WQ

Bag, flexible container

Crate, milk